Make your own
Home Up Operating Instructions Make your own

 

Clay Gun Extruder Adapter
The secret to making a clay gun extruder work easily is to buy a caulk gun with a 15:1 thrust ratio.  This makes pushing the clay out easily with one hand.  If the thrust ratio is lower, it is harder to push.

Caster Cup - the dark brown piece		 Using a strong glue, attach a Caster Cup to the end of the pusher.

Pipe Fitting - the white piece
Washer - the gold piece		 You also need a pipe fitting that your clay gun will fit in.  Use a rubber washer to keep it from wiggling around.

Next you need a metal washer that will slip over the end of your clay gun.

[ Home ] [ Copyright Policies ] [ Club Terms and Conditions ]

Tips and suggestions are presented in good faith.  Proper use of any product requires following the manufacturers instructions.
This site disclaims any and all liability for untoward results.
The use of products and trademark names are for information purposes only, with no intention of infringement upon those trademarks.

Send mail to Trish@polyclayplay.com with questions or comments about this web site.

Copyright ©2006, 2007 Trish Hodgens
All rights reserved. Nothing on this site may be reproduced without the written permission of Poly Clay Play.